innovaphone IP DECT Page 31
4.1.2.5 Configuration/IP/PPP State
The state for all defined and enabled PPP interfaces is displayed here. In additi-
on, it is possible to manually close the connection and set it up again.
4.1.2.6 Configuration/IP/Routing
The routing table of the current IP configuration of the gateway is displayed
here. The table is used for fault analysis by the network administrator. The table
is structured as follows:
Interface ID of the PPP interfaces.
Address The local IP address of the PPP interface.
Type The interface type: PPTP, PPPoE or, in the case of PPP using an
ISDN channel, one of the ISDN interfaces.
State Displays the current state of the interface. Possible states:
Connecting, Up
or
Down
.
Since The time as of when the connection exists is specified here.
Action •
connect
establishes a connection to the selected inter-
face.
•
clear
deletes the current connection to the selected inter-
face.
•
info
displays relevant connection data for the selected
interface.
Name The name of the interface or connection.
Destina-
tion Net-
work
The destination network address.
Network
Mask
The associated network mask.
Gateway The IP address of the default router.
Interface Displays the interface on which the route was created. Possible
interfaces are:
ETH0
,
ETH1
,
PPP0-31,
Local
and
ISDN.
State Possible states are:
Up
or
Down.
To Next Page
Loading...
