innovaphone IP DECT Page 33
In the as-shipped state, ETH0 is configured in
DHCP Automatic mode
with the
IP address 192.168.0.1 and ETH1 is configured in
DHCP Disabled mode
with
the IP address 192.168.1.1.
4.1.3.3 Configuration/ETH0-1/IP
The manual configuration settings are effective if the DHCP mode
Disabled
or
Server
is configured. To the right of the entry fields, the settings currently stored
are always displayed.
Automatic The first time the device is switched on (powered up), ETH0
works as a DHCP client. After a restart through briefly pressing
the Reset button, the ETH0 interface is allocated the configu-
red IP address. If an IP address was not explicitly configured
(see chapter “
Configuration/ETH0-1/IP
”), the IP address
192.168.0.1 is specified as standard.
Caution
DHCP Automatic mode
should not be used for ‘normal’ operation, since an
accidental restart switches the operating mode.
IP Address The IP address of the network adapter.
Network
Mask
The subnet mask of the network adapter.
Default
Gateway
The standard router of the LAN.
DNS Server The DNS server of the LAN.
Proxy ARP Where IP packets are routed from Ethernet to PPP interfaces
via the device, the device can appear to the local network as if
it were the addressed terminal itself. This also allows IP termi-
nals on the same Ethernet segment, which do not have a cor-
rect routing entry, to communicate over the device and use the
WAN connection. To allow dial-in access to the entire network,
the
Proxy ARP
function must be enabled.
To Next Page
Loading...
