Innovaphone IP6000 - Gateway Object; Mcast Announcement Object

innovaphone IP DECT Page 59
Every call received by the boss that was previously received by the secretaries is
likewise signalled as a diverted call. It is thus possible to adjust the boss’s ring
tone, so that it rings differently if the call was initialised by one of the secretaries.
If a call is received directly on the boss’s phone, that is, not via the secretaries,
it can be signalled with a different ring tone.
The following specifications are made in the EXECUTIVE section:
If no secretary groups have yet been created for this object, the Primary, Se-
condary and Direct Call entry fields are empty.
4.2.1.4.7 Gateway Object
The Gateway PBX object is used to register a gateway with the PBX. The Gateway
PBX object thus provides the direct dialling capability with or without prefix.
4.2.1.4.8 MCast Announcement Object:
The MCast Announce PBX object allows a call to be put through directly on se-
veral telephones. For this, a group must be defined for the MCast Announce ob-
ject, and all subscribers belonging to this group are addressed.
The following specifications are made in the
Multicast section:
Primary The
Primary secretary group, when added, may be selected
here.
Secondary The
Secondary secretary group, when added, may be selec-
ted here.
Direct Call The
Direct Call secretary group, when added, may be selec-
ted here.
Call Exe-
cutive
Calls to the secretary’s phone are also signalled on the boss’s
phone, if this check box is checked.
Enblock
Count
Time (in seconds), after which the call set-up begins.
Prefix A prefix can be added.
Multicast
Address
A multicast IP address must be specified. For IPv4, the multi-
cast address range 224.0.0.0 to 239.255.255.255
applies.