innovaphone IP DECT Page 91
4.2.4.2 Administration/Upload/Firmware
This function allows you to manually upload a new firmware version onto the
VoIP device. This can be automated by configuring an update server as described
in the chapter “
Configuration/General/Update
”. New firmware versions can be
obtained from a certified innovaphone dealer or directly via the innovaphone ho-
mepage (http://www.innovaphone.com).
By specifying path and file name of the configuration file to be loaded in the
Firmware File field and then clicking the Upload button, the configuration file
is loaded into the device.
Whilst loading the new firmware, you are advised not to interrupt the loading
procedure under any circumstances.
If the loading procedure is nevertheless interrupted, the device should under no
circumstances be switched off afterwards. Rather the procedure should be re-
peated once the problem has been eliminated.
Take a look at the documents supplied with the new versions to find out whether
new boot firmware also has to be loaded. If this is the case, it must be ensured
(if specified) that the required sequence of boot code and firmware update is ob-
served.
The new firmware is not activated directly. A reset must be performed to activate
the new version. The immediate reset and reset when idle links are provided
for this purpose. More detailed information on resetting the gateway is contained
in the chapter entitled “
Administration/Reset
”.
4.2.4.3 Administration/Upload/Boot
This function can be used to load a new boot code version onto the VoIP device.
New boot code versions can be obtained from a certified innovaphone dealer.
By specifying path and file name of the boot code firmware to be loaded in the
Boot File field and then clicking the Upload button, the boot code firmware is
loaded into the device.
Whilst loading the new boot code firmware, you are advised not to interrupt the
loading procedure under any circumstances.
If the loading procedure is nevertheless interrupted, the device should under no
circumstances be switched off afterwards. Rather the procedure should be re-
peated once the problem has been eliminated.
The new boot code is not activated automatically. A reset must be performed to
To Next Page
Loading...
