Innovaphone IP6000 - Configuration;General;Snmp; Configuration;General;Telnet; Configuration;Ip

innovaphone IP DECT Page 23
4.1.1.9 Configuration/General/SNMP
The VoIP device allows the operating state to be monitored using SNMP (Simple
Network Management Protocol with version 1.0). Standard MIB II and a
manufacturer-specific MIB (Management Information Base) are supported.
Detailed information about this MIB can be obtained from a certified
innovaphone dealer or downloaded directly in the download area of the
innovaphone homepage (http://www.innovaphone.com).
4.1.1.10 Configuration/General/Telnet
Access via the Telnet protocol can be enabled here.
4.1.2 Configuration/IP
General IP protocol settings are made here, as well as the configuration of the
Community If the standard community name
public is not being used, a
different community name can be entered in this field.
Device
Name
For more detailed information, a device name can be specified
here for the SNMP agent.
Contact As can a contact person (Contact).
Location As can a location (Location).
Authentica-
tion Trap
Access via SNMP is only possible if the correct community
name is entered. If this check box is checked, a trap is genera-
ted in the case of access with an incorrect community name.
Trap Desti-
nation
Destinations for trap messages also have to be defined if the
device is to trigger the traps defined in the manufacturer-spe-
cific innovaphone MIB.
Allowed
Networks
To increase security, access to the device can be restricted by
restricting SNMP access to a defined list of computers or IP
address ranges.
Enable Tel-
net
A checked check box enables access to the device using telnet.
The device can be configured with commands such as reset,
config change UP1 /url <http url> /poll <secs> , for example.