innovaphone IP DECT Page 57
4.2.1.4.3 Call Broadcast Object:
With the
Call Broadcast
PBX object, it is to possible to distribute all calls arriving
on this object to all member of a group that this Call Broadcast object belongs
to. Here, it is possible to allocate a call number to this object, enabling in turn a
call diversion, if say the subscribers of the Broadcast group are busy or cannot
be reached.
The following specifications are made in the Broadcast section:
4.2.1.4.4 DECT System Object
To be able to register a DECT system in the innovaphone PBX, a
DECT System
PBX object is required. All DECT-specific information is stored in this
DECT Sy-
stem
PBX object. During initial start-up of a DECT system, this object must be
created in an existing innovaphone PBX environment.
Note
The current state of the Boolean object is visible in the
Boolean
section under
chapter “
Administration/PBX/Filter
”.
Execute
Group
Member
Diversions
In the case of a call to a subscriber of a Broadcast group with
enabled call forwarding, no call forwarding is evaluated as
standard. With a checked check box, the call forwarding of
the subscriber is evaluated in the case of a call to the Broad-
cast group.
Round
Robin
Timeout
(s)
With the Round Robin Timer (RRT), an algorithm can be
enabled which, after the specified interval has elapsed,
signals incoming calls to the next subscriber of the Call
Broadcast group.
A case example would be the support department of a com-
pany created as the Call Broadcast object. Several support
staff belong to this object. By specifying the RRT, call distri-
bution to the support staff can be automated. Here, the RRT
is so intelligent that it makes a note of the last phoning subs-
criber and misses this subscriber out in the next signalling.
To Next Page
Loading...
