page 92 innovaphone IP DECT
activate the new version. The immediate reset and reset when idle links are
provided for this purpose. More detailed information on resetting the device is
contained in the chapter entitled “
Administration/Reset
”.
Take a look in the documents supplied with the new versions to find out whether
new protocol firmware also needs to be loaded.
4.2.5 Administration/Diagnostics
The Diagnostics menu can be used to monitor the operating state of the device.
4.2.5.1 Administration/Diagnostics/Logging
Using the Syslog link, the log messages of the device can be viewed directly in
active operation. The messages are continuously automatically updated and are
scrolled upwards, out of the window.
Only messages that were enabled in the Logging submenu are displayed. The
following settings can be enabled:
TCP All TCP connections.
PPP All PPP connections.
Relay Calls All calls that go via the Relay – only visible for devices with S
0
or S
2
m interface.
Relay
Routing
All calls that must be routed via the Relay – only visible for
devices with S
0
and S
2
m interface.
DECT
master
All DECT master connections – only visible for IP DECT
systems.
DECT
radio
All DECT radio connections – only visible for IP DECT
systems.
H.323
Registrati-
ons
All H.323 registrations.
SIP Regi-
strations
All SIP registrations.
Config
Changes
All configuration changes.
TEL1-n All TEL1-n connections – only visible for devices with TEL
interface.
To Next Page
Loading...
