innovaphone IP DECT Page 51
Registrations section:
4.2.1.2 Administration/PBX/Password
For the operation of the innovaphone PBX, a PBX password must be allocated.
This password is used for the authentication of the standby PBX, as well as for
the encryption of user passwords, amongst other things:
4.2.1.3 Administration/PBX/Filter
In the innovaphone PBX, it is possible to define global call filters. In this way,
various rights for phoning can be assigned to, or withdrawn from, the users.
Here are a few filter examples:
Limit The maximum number of registrations of the device.
Current The current number of registrations already performed.
Password The PBX password.
Retype You must repeat the entry of the PBX password.
Name The descriptive name of the filter. The name may not be
ok
or
nok
, since these names refer to filter properties.
Not / Boolean A filter can be made dependent on the state of a Boolean
object. If a Boolean object was defined here, the filter is
only effective if the Boolean object is set to
true
, unless
the
Not
check box is checked. Then the filter would only
be effective if the Boolean object is set to
false
.
Number The call number or prefix to be filtered.
Next (ok/nok/
filter)
Possible entries:
ok
,
nok
,
Filter name (for calling up a fur-
ther filter with the designated filter name)
.
Example 1 (allow
only internal calls)
Name: Internal Prefix: 0 Action: nok
Result: Only internal calls. All calls beginning with 0 are
blocked.
To Next Page
Loading...
