page 42 innovaphone IP DECT
Replication is required in three application cases:
1. Replication of the user data from the master PBX to a standby PBX. The repli-
cator configuration takes place on the standby PBX.
2. Replication of the user data from the master PBX to a slave. The replicator
configuration takes place on the slave.
3. Replication of the user data from a DECT master to a DECT radio. The repli-
cator configuration takes place on the DECT radio.
4.1.4.4 Configuration/LDAP/Replicator-Status
The displayed replicator status data is automatically updated at intervals. In ad-
dition, the last ten activity messages of the replication are displayed:
Server The LDAP server IP address.
Location To replicate only the objects of a particular location in the sense
of a partial replication, the name of the location (PBX name)
can be specified here.
User &
Password
The LDAP user and password. Is stored on the LDAP server
under the chapter “
Configuration/LDAP/Server
”.
Enable A replication only takes place if the Enable check box is chek-
ked.
Server IP address and port of the remote LDAP server.
Full Repli-
cation
Current state of the replication. There are four states:
Stop
,
Starting
,
Up
,
Down
.
remote Displays the state of the replication in poll direction.
notify Number of received notifications.
modify Number of modified objects.
local Displays the state of the replication in push direction.
add Number of locally added objects.
del Number of locally deleted objects.
modify Number of locally modified objects.
notify Number of notifications that have arisen locally.
pending Number of locally waiting objects.
To Next Page
Loading...
