MEDIAJET – Operating instructions V09 Installation
15
www.integra-biosciences.com
3 Installation
Purpose This chapter shows the unpacking and installation of MEDIAJET.
3.1 Unpacking
3.2 Preconditions
3.2.1 Operating environment
Generally inadmissible are locations with which there is a risk of spray water or
of contact with chemicals. The correct location satisfies the form of protection IP
21 and has a stable, horizontal base.
In the event of failure to observe the ambient conditions for the location, the
capacity to function and the safety cannot be guaranteed.
ASSISTANCE
Check the scope of delivery for any transport damage and notify your local
INTEGRA Biosciences AG representative (see last page of the operating
instructions).
Unpack the MEDIAJET and check the
scope of delivery (see “2.1 Scope of
delivery” on page 8).
Ambient temperature for operation 15-35°C
Maximum relative humidity Non-condensing, 30-80 % for up to
35 °C
Voltage fluctuations of the mains
supply
+/-10 % from the nominal value
Degree of contamination 2 as per IEC 60664-1
Ingress protection according to IEC 60529:
IP20 - Protection against objects >12.5 mm
To Next Page
Loading...
