MEDIAJET – Operating instructions V09 Operation
28 INTEGRA Biosciences AG
.
Move the filling nozzle holder in the direction of the Petri dish, so that the drive
wheel pushes against the Petri dish without tilting it up. The drive wheel
should rotate the Petri dish easily.
Tighten the screws of the filling nozzle holder.
Press TEST to check the automatic alignment of the dividing wall of the Petri
dish.
The dividing wall is aligned at a right angle to the filling nozzle holder and
“Test: OK” is displayed.
4.3 Loading Petri dishes
Select LOAD CAROUSEL in the MAIN MENU and choose the mode of the
planned filling process:
Insert a Petri dish into the rotor in front of the
filling nozzle.
Unscrew the two screws of the filling nozzle
holder and move it to the leftmost position.
Press ON / OFF DRIVE to start the drive
unit for adjusting.
ASSISTANCE
If the biplate option is not required, move the filling nozzle holder to the
rightmost position and use the right filling nozzle.
Press NORMAL to prepare filling of all
dishes stack by stack or BATCH for filling
the dishes in the Batch mode, see “4.4
Adapting a dish filling program” on page 30.
MEDIAJET now carries out an automatic
self-calibration process.
ASSISTANCE
The two positions refer to the two locations situated directly in the front side of
the carousel towards the operator above the two cavities in the black cover
plate.
To Next Page
Loading...
