Integra MEDIAJET - Biplate Option Installation and Setup

MEDIAJET – Operating instructions V09 Installation
21
www.integra-biosciences.com
3.4.5 Base plate for filling nozzle holder
For filling of Petri dishes with a height above 21 mm a base plate, used as a
spacer, must be mounted.
For MEDIAJET vario with biplate option, a special base plate must be mounted,
if Petri dishes with a height above 21 mm are filled:
3.5 Biplate option
The biplate option allows the filling of two Petri dish compartments in parallel by
two filling nozzles and a double pump head (available only with MEDIAJET vario
with biplate option, Part No. 113 002).
 Remove the two screws below the caps on
the filling nozzle holder.
 Place the base plate under the filling nozzle
holder and fix it with the long screws
supplied with the base plate.
 Put the screw caps on the screws.
 Remove the two screws of the filling nozzle
holder.
 Place the base plate for biplate option under
the filling nozzle holder, so that the two L-
shaped openings of the base plate are
stacked below those of the filling nozzle
holder.
 Fix the stack with the screws of the filling
nozzle holder.
 The filling nozzle holder must be adjusted,
see “4.2.3
Biplate (optional)” on page 27.
 Enable the biplate alignment under program
configuration, see “4.2 Adapt system
parameter” on page 26.