Integra MEDIAJET - TUBEFILLER Option

MEDIAJET – Operating instructions V09 Optional functions and required accessories
64 INTEGRA Biosciences AG
7.8 TUBEFILLER option
The TUBEFILLER option is a perfect expansion to the functionality of
MEDIAJET. It allows quick conversion of MEDIAJET into a test tube filler. The
option has to be ordered separately from INTEGRA BIOSCIENCES.
The following accessories are available for the TUBEFILLER:
Device Option Part No.
TUBEFILLER option for MEDIAJET, including
filling arm, support plate compatible with racks
of
 13, 16, 20, 25 or 30 mm test tubes and a
3.0mm silicone tubing set with two dispensing/
aspiration tubes.
103 010
Accessories Part No.
Test tube Racks
10 units of autoclavable at max. 121°C
polypropylene test tube racks.
Rack for
13 mm test tubes, 6 x 15 capacity 103 070
Rack for
16 mm test tubes, 5 x 12 capacity 103 071
Rack for
20 mm test tubes, 4 x 10 capacity 103 072
Rack for
25 mm test tubes, 3 x 8 capacity 103 073
Rack for
30 mm test tubes, 3 x 7 capacity 103 074
Centring Plates
required to provide an accurate positioning of
 16, 20 or 25 mm test tubes, which are longer
than 15 cm, during the filling process.
Centring plate for 16 mm test tube rack 103 065
Centring plate for
20 mm test tube rack 103 066
Centring plate for
25 mm test tube rack 103 067
Aspiration/dispensing tubes
Aspiration/dispensing tube 2.0 mm ID, 10 cm
length, stainless steel
171 052
Aspiration/dispensing tube 3.0 mm ID, 10 cm
length, stainless steel
171 053
Aspiration/dispensing tube 4.0 mm ID, 10 cm
length, stainless steel
171 054
Tube collar as weight
for aspiration tubes with 1-3 mm ID 171 071
for aspiration tubes with 4-6 mm ID 171 074