Intel Express 460T User Manual

54
CHAPTER 5 Intel Express 460T Standalone Switch Users Guide
Using Telnet
1 Open a Telnet application. In Windows 98 or Windows NT*, select Run
from the Start Menu and then type: telnet E.
2 On the Terminal menu, select Preferences. Make sure the emulation type
is VT-100/ANSI and that VT100 arrows are enabled.
3 On the Connect menu, select Remote System. Enter the IP address of
the switch and click Connect. (The default IP address is 192.0.2.1.)
4 Log on to Local Management. By default, no password or username is
assigned.
Logon Screen
Description
By default, no username or password is assigned to the switch. Press
E twice to log on to the Local Manager. Usernames and passwords
can consist of any characters and can be up to fifteen characters in length.
Remember that usernames and passwords are case-sensitive.
NOTE
To access the switch using Telnet,
your workstation must be in the
same subnet as the switch.

Intel Express 460T Specifications

General

Brand	Intel
Model	Express 460T
Category	Switch
Language	English