Intel Express 460T

122
APPENDIX A Intel Express 460T Standalone Switch Users Guide
Sample Configuration File
The following is an example of a configuration file.
###### Intel Express 460T Standalone Switch Configuration File ##############
#
# Lines beginning with a "#" character are comment lines.
###### IP Address Configuration ############################################
#
# Ip_addr= <ipaddress> IP address used by the switch
# Subnet_mask= <ipaddress> Specify default gateway
# Default_gateway= <ipaddress> Specify subnet mask
#
Ip_addr= 124.123.122.121
Subnet_mask= 255.255.255.0
Default_gateway= 124.123.122.254
###### Console and Configuration File Information ##########################
#
# Specify the code type of the image file
#
# Code_type=PROM Image type is PROM code
# Code_type=RUNTIME Image type is runtime firmware
# Code_type=CONFIG Image type is saved configuration file
Code_type=PROM
#
# Image_file= <path> Path and filename of runtime image or PROM image files
Image_file="e:\update\E460PROM.tfp"
###### Port Level Configuration #############################################
#
# Static_fdb_list={(MAC address, port #)} MAC address and port# of static entries
# Port_nway_enabled_list={port#, port#, . . } Ports set to auto-negotiate
# Port_flow_ctrl_enabled_list= {port#, port#, . .} Ports that have flow control enabled
# Port_backpressure_enabled_list= {port#, port#, .} Ports that have back pressure set
# Port_priority_list= { H (high), L (low), . .} Sets 802.1p priority queues
# Port_stp_enabled_list= {port#, port #, . .} Ports that are enabled
# Port_disabled_list= {port#, port#, . .} Ports that are disabled
Static_fdb_list={ (0080c8001121, 1) (0080c8001122, 2) (0080c8001123, 3) }
Port_nway_enabled_list={3,5,7}
Port_flow_ctrl_enabled_list = {3,4,5,7}
Port_backpressure_enabled_list = {16, 15, 14 }
Port_priority_list = { H,L,A,L,H,A,A,L,H }
Port_stp_enabled_list = {8,9,10,11, 20, 21, 23 }
Port_disabled_list = { 20,21,22,23,24,25 }
###### Link Aggregation #############################################
#