Setting Up the Chassis
Intel® Server Chassis SC5300 User Guide 9
2. Setting Up the Chassis
This chapter describes how to set up your server chassis for the first time.
Tools and Supplies Needed
Phillips (cross head) screwdriver (#2 bit)
Small flat-head screwdriver
Anti-static wrist strap (recommended)
Installation Safety Instructions
Only technically qualified personnel should integrate this assembly.
Follow these guidelines to meet and maintain safety and product regulatory requirements when
integrating this chassis subassembly.
Read and adhere to all of these instructions and the instructions supplied with this assembly. If you
do not follow these instructions, the UL listing will be void, and the product will most likely be
non-compliant with other regional product laws and regulations.
Safety: Before You Remove the Access Cover
Before removing the access cover for any reason, observe these safety guidelines:
Turn off all peripheral devices connected to the server.
Turn off the server by pressing the power button on the front of the chassis. Then unplug the
AC power cord from the chassis or wall outlet.
Label and disconnect all peripheral cables and all telecommunication lines connected to I/O
connectors or ports on the back of the chassis.
Provide some electrostatic discharge (ESD) protection by wearing an antistatic wrist strap
attached to chassis ground—any unpainted metal surface—when handling components.
To Next Page
Loading...
Need help?
General
