5-35-25-1
: 5EA
5. Remove the xing screws (5EA) from the remaining side panels, then detach the side panels.
Removing Antenna from Wooden Crate
Four radome brackets secure the antenna to the pallet.
To remove the radome bracket, follow the procedures
below.
1. Remove the xing screw(2EA) on the radome bracket that
secures
the antenna to the pallet using a
wrench.
2. Loosen the radome bolt (1EA) counter-clockwise using a wrench then slide the radome bracket to the
left side to remove that.
3. After removing radome bracket, apply Loctite #263 to the bolt's threads to ensure the bolts are fastened
rmly. Fully tighten the radome bolt (1EA) clockwise using a wrench. Apply the same procedure to all
four parts.
Fixing Screw
(2EA)
1
3
2-1
A
Radome
Bolt
2-2
B
Radome
Bracket
Fully Tighten Radome Bolt
To Next Page
Loading...
