LP600 Users Manual
Rev E, February 2017
Page 11 of 43
system is re-zeroed. This switch is used any time the scale shows a non-zero
value with no weight on the pads.
Note: This system contains a feature called Auto Zero Tracking (AZT), which
corrects for slight zero changes during normal operation. An example of a zero
change could be a buildup of dirt on the pads.
Another function of the zero key is to clear the accumulated total. Press and
hold the ZERO key until the display reads “.“and release the ZERO key.
This will reset the accumulated total and the accumulation number. All other
scales you have connected will also be zeroed through the interconnect cables.
This allows you to zero your entire system with one key press.
To Next Page
Loading...
