Intercomp LP600 - Calibration Menu

LP600 Users Manual
Rev E, February 2017
Page 31 of 43
Calibration menu
To initiate calibration simultaneously press the PRINT/ACCUMULATE and ZERO
buttons. The display will show “”, if it does not, the calibration strap is incorrectly
placed to allow calibration. Return to ‘Calibration Enable Jumper’ section to verify
correct setting. Press the PRINT/ACCUMULATE button to access the parameter
setting.
At times it will be necessary to enter up to a five digit number. When this is necessary
the current number will be displayed with the right most digit flashing. The flashing digit
may be incremented by pressing the LOCAL/TOTAL button. To move one digit to the
left, press the ZERO key. When you have finished entering a number press the PRINT/
ACCUMULATE button. The settings are saved once PRINT/ACCUMLATE is pressed to
advance the menu, and the scale can then be turned off.
Step
Function
Note
Default

skip
000= no skip
See Calibration “Step” codes

.
Unit enable
Yes or no


grad break point 1
Enter weight


grad break point 2
Enter weight


grad break point 3
Enter weight

.
ADC rate
0 or 1


AZT (auto zero tracking)
1 d, 3 d, .5 d, oFF, or.6 d

.
Zero range
0= off, 1= 1%, 2= 2%, 3= 5%,
4 = 1%

g
graduation size
0.02, 0.05, 0.1, 0.2, 0.5, 1, 2, 5,
10, 20, 50, or 100



Displays for 1 sec and advances

capacity
Enter scale capacity


No weight applied

First weight
Enter first weight


First weight
Load first weight

Second weight
Enter second weight

Second weight
Load second weight

Third weight
Enter third weight

Third weight
Load third weight

Fourth weight
Enter fourth weight

Fourth weight
Load fourth weight
10 points available to enter
3 minimum recommended