Intercomp LP600 - Continuous Mode; Data Format; Accumulating Print

LP600 Users Manual
Rev E, February 2017
Page 14 of 43
Continuous
The LP600 automatically and continuously outputs the weight at a rate of about
once per second.
Data Format
When the serial output is set to either on-demand or continuous mode,
the transmitted data is in the format shown below:
AAAAAAA BB<cr><lf>
Item
Meaning
ASCII Hex
ASCII Decimal
AAAAAAA
weight
BB
units “lb” or “kg”
<cr>
carriage return
0D
13
<lf>
linefeed
0A
10
The AAAAAAA field will vary in length depending on the length of the
number and could contain a decimal point and/or a minus sign. The
weight will either be local weight or total weight, depending on which
mode you’re in.
Accumulating Print
See section titled “Using Accumulated Total” for both the Axle and the standard
formats.