LP600 Users Manual
Rev E, February 2017
Page 10 of 43
Once a successful accumulation has a occurred, the scale will automatically
toggle it’s display to show the current weight, accumulated total, and number of
accumulations.
Note: The scale will not accumulate and will display the error message “.”
if the current weight is negative, zero, or if the weight is in motion. These
Protections are added to ensure that only valid readings are accumulated into
the total. Also, after a successful accumulation, ALL scales in the system must
return to zero before you accumulate the next weight. If you attempt to
accumulate the next weight before allowing the scale(s) to return to zero, the
error message “.” will be displayed.
The accumulated total weight can be viewed only on the scale you are
accumulating from. After the PRINT/ACCUMULATE button is first pushed; the
display will show “. X” as the system will accumulate the next reading and
send it to print. (X will show the number of accumulations this session) Once a
successful accumulation has occurred, pressing the LOCAL/TOTAL button will
cycle the display to show number of accumulations, current local weight, current
total weight on all scales, and the accumulated total. When the local weight,
current total weight, or accumulated total is displayed, the total icon will be lit up,
flashing, or off. (as shown in the display description).
LOCAL / TOTAL
This control will be rarely used with a LP600 system. This function is used in
cabled scales with no central CPU or indicator.
The local weight is the weight on that scale only. The total weight is the weight
on all of the scales in your system. Pressing the LOCAL / TOTAL button toggles
between local weight and total weight. The Mode status (as shown in the display
description) will show whether the scale is displaying the local or total weight.
Note: If the system is not setup correctly, the “error” icon and message “” will
be displayed when trying to view the total weight. See section titled “Totalizing
Setup”.
ZERO
Sets the weighing system to read zero pounds or kilograms. If pressed while a
pad holds weight, that weight becomes the zero condition for the pad. This can
be useful to cancel the weight of any weighing fixtures, such as tail cones or
wheel chocks. When the weight is removed, a negative weight displays until the
current weight
displayed for
5 seconds
total accumulated
weight displayed
for 2 seconds
total number of
accumulations
displayed for 1 second
To Next Page
Loading...
