Interlogix xGenConnect NXG-8-Z-B0 - Page 131

xGenConnect Installation and Programming Guide 119
Programming Sequence
6. Communicator
5. Channels
18. Channel Groups
a) Options
→
→
→
b) IP Config
c) Ethernet
d) Radio
e) Dial IP
6. Communicator
f) Email
17. Event Lists
g) Remote Access
h) System Event
Reporting
18. Channel Groups
4. Areas
12. Area Groups
a) Area Options
→
b) Area Timers
c) Area Reporting
7. Schedule
18. Channel Groups
Instructions
1. Go to Areas.
2. Select an Area Number.
3. Enter a descriptive name.
4. Select the Options you want to enable for this Area. Area 2 and above have
“Use Area 1 Options” ticked to allow faster programming of your system.
Untick this box if you want to customize options for Area 2 and above.