Interlogix xGenConnect NXG-8-Z-B0 - Adding Xgenconnect to Existing Z-Wave Network as Primary Controller

78 xGenConnect Installation and Programming Guide
4. Press the Exclude button on the xGenConnect (the secondary device):
5. Primary Controller will remove xGenConnect from it.
6. xGenConnect status will update to indicate it has been added as Secondary
Controller.
7. Save settings on Primary Controller.
Adding xGenConnect to existing Z-Wave network as
Primary Controller
1. Log in to the panel.
2. Click Settings > Z-Wave Add/Remove.
3. Start the Control Shift function on the primary controller of the existing
network. This will typically involve pressing a “Shift” button.