Interlogix xGenConnect NXG-8-Z-B0 - Programming Instructions for Communicator

130 xGenConnect Installation and Programming Guide
Arm-Disarm Number 1 – Arm-Disarm Example
Schedule 4 – Office Hours
Mon – Fri
9 AM – 5 PM
→
See “Programming Instructions for
Schedules” on page 121 to program
User 55 – Arm-Disarm User
→
See “Programming Instructions for Users”
on page 109 to program
Permission 99 – Full Access
→
See “Programming Instructions for
Permissions” on page 102 to program
Arm Area Group 1
1, 2, 3
Arm Area Group 1
1, 2, 3
Schedule 1 – Full Access
7 days, 24 hours
→
See “Programming Instructions for
Schedules” on page 121 to program
Programming Instructions for Communicator
Goal
Configure each communication path for delivering event messages.
Pre-conditions
None.
Programming Sequence
6. Communicator
a) Options
b) IP Config
c) Ethernet
d) Radio
e) Dial IP
f) Email
g) Remote Access
h) System Event Reporting
18. Channel Groups