xGenConnect Installation and Programming Guide 49
Programming with Web Pages
Most commonly used features can be programmed from the xGenConnect Web
Server > Settings menu. The same menus are displayed from the UltraSync+
app by clicking Menu > Settings.
Recommended Items to Change
• Installer Code. This is the master key to most features. Always change this to
prevent accidental modifications by end-users and unauthorized access to the
security system.
• User 1 PIN code is 1234 at default. Always change this to prevent
unauthorized access to the security system.
Note: EN 50131 Grade 3 default codes are 971300, 123400.
• User 1 username is “User 1” at default, there is a space between “User” and
“1”. Usernames are required to provide access to the xGenConnect Web
Server and UltraSync+ app.
• Web Access Passcode. This provides access to the xGenConnect Web
Server, UltraSync, and UltraSync+ app.
• DLX900 access for upload/download is allowed if the panel is at factory
default with the installer account set to PIN 9713. This is a convenience
feature to allow the installer to connect to the panel for the first time and
perform a Send All to program the panel. Once the installer PIN is changed,
To Next Page
Loading...
