xGenConnect Installation and Programming Guide 133
9. Click System Event Reporting.
10. Select the channel group to send system events (e.g. low battery).
Next
• Perform tests on each of the communication paths to verify they are
functioning correctly.
• Program Channels.
• Program Channel Groups.
• Verify Number of Attempts, next channels (back-up channels), and multi-path
reporting function correctly.
Programming Instructions for UltraSync
Pre-conditions
At least one user has been given a username and PIN code (see “Programming
Instructions for Users” on page 109).
xGenConnect is connected to internet and has been allocated an IP address
(see “Programming Instructions for Communicator” on page 130, IP Config).
Notes:
UltraSync provides a secure VPN connection to your xGenConnect system over
the internet. You will need to provide your xGenConnect serial number, Web
Access Passcode, and a valid Username and PIN code that exists in your
xGenConnect system. These codes provide multiple levels of security for the
connection.
The Web Access Passcode is needed for:
• Web console over the internet via a secure VPN
• UltraSync+ app
• DLX900 software connecting over IP, in addition to Download Access Code
The Web Access Passcode is NOT needed for:
• Email services
• Web console over a local LAN connection
Once UltraSync is set up, you may connect to your xGenConnect system using
the UltraSync+ app on your smartphone or tablet. This may require a separate
To Next Page
Loading...
Need help?
General
