ZeroWire Installation Manual 21
• Turn chime mode on and off
• Bypass/Un-bypass sensors
• Add, remove and edit users
• Add, remove and edit Z-Wave devices
• View Z-Wave device status
• Control Z-Wave devices
• Enter Installation menu and perform advanced programming for ZeroWire
WiFi Discovery Mode
ZeroWire provides a temporary WiFi Discovery Mode to allow initial configuration from a
mobile device such as a smart phone or tablet. This wireless connection is between the
ZeroWire and the mobile device only.
1. Power on - Connect power to your ZeroWire
2. Enable WiFi on ZeroWire - On the ZeroWire press Menu – 9 – [PIN] – 8. This will
enable WiFi Discovery Mode for 10 min.
3. Enable WiFi on your device - Turn on WiFi on your smart phone, tablet, or laptop.
4. Connect to ZeroWire - Browse for available WiFi networks and select the
‘ZeroWire_xxxx” network to connect to it. Only a single user can connect at any time
and there is no WiFi password. Once connected the ZeroWire will be assigned a fixed
IP address of 192.168.1.3.
5. Open Web Browser - Open your web browser and enter http://192.168.1.3. The
ZeroWire login screen should appear:
6. Login - Enter your username and password, by default this is “installer” and “9713”
http://192.168.1.3
To Next Page
Loading...
