Before You Begin
x Intermec EasyCoder PD4—Service Manual
About This Manual
This Service Manual is intended to facilitate installation, troubleshooting
and repair of the Intermec EasyCoder PD4 printers in the versions deliv-
ered at the date of publishing. Thus, all information on the Intermec ESim
fi rmware is based on version 5.00. The on-going product improvement can
be followed in the Printer Technical Bulletins from Intermec.
Please note that the operations described in this manual only should be car-
ried out by skilled and authorized personnel with proper training and full
understanding of written English. The printers contain wires and circuits
with high voltage, which implies the risk of electrical shock. Moving parts
may also cause harm, if incorrectly manipulated.
It is assumed that the reader possesses reasonable skills in mechanics and
electronics and is familiar with the Intermec ESim protocol. It is also
assumed that the reader has access to the standard tools of an electronics
workshop.
All screws are Phillips type (PH1 or PH2).
To Next Page
Loading...
