Intermec EasyCoder PF2i - Page 245

Intermec EasyCoder PF2i, PF4i, and PF4i Compact Industrial—Service Manual 237
Chapter 15—Troubleshooting
Description:
The cutter cuts at the wrong place.
Possible Causes and Sugged Remedies:
• Faulty LSS or bad Feedadjust setup.
- In Fingerprint, perform a Testfeed to adjust the LSS.
- In IPL, adjust the media feed by pressing the Feed/Pause button.
- Check Start- and Stopadjust setup values (Fingerprint only).
- Check application for FORMFEED<nnn> instructions (Fingerprint
only).