EasyCoder PX6i User’s Guide (Fingerprint version) 87
Chapter 8 — Intermec Shell Startup Program
• Update fi rmware is used to directly upgrade the fi rmware of a specifi c
printer from a new fi rmware version stored as a fi le in a PC. If the
printer is equipped with an EasyLAN Ethernet or Wireless board, the
user must have access rights to upgrade the fi rmware, see the EasyLAN
User’s Guide.
If the CompactFlash card or upgrade fi le contains an earlier
fi rmware version than the one in the printer, the printer’s
fi rmware will be downgraded without warning.
Firmware upgrade fi les can be found on www.intermec.com or be
obtained from your local Intermec distributor.
Reboot
Corresponds to cycling the power to the printer. To exit Intermec Shell
without having selected any application, select Reboot. Then wait for the
5 seconds countdown to fi nish, and the last selected application will be
opened.
To Next Page
Loading...
