EasyCoder PX6i User’s Guide (Fingerprint version) 129
Appendix B — Media Specifi cations
Self-Adhesive Labels
⇐ a ⇒ Media Width (including liner)
Maximum: 170 mm (6.69 inches)
Minimum: 76 mm (3.00 inches)
⇐ b ⇒ Liner
The backing paper must not extend more than a total of 1.6 mm (0.06
inches) outside the labels and should protrude equally on both side. Rec-
ommended minimum transparency: 40% (DIN 53147).
⇐ c ⇒ Label Width (excluding liner)
Maximum: 168.4 mm (6.63 inches)
Minimum: 74.4 mm (2.93 inches)
⇐ d ⇒ Label Length
Maximum:
8 dots/mm (203.2 dpi): 6,143 mm (241 inches)
11.81 dots/mm (300 dpi): 4,162 mm (163 inches)
provided there is a suffi cient amount of free SDRAM memory
Minimum (without LTS): 8.0 mm (0.32 inches)
Minimum (with LTS): 12.0 mm (0.47 inches)
⇐ e ⇒ Label Gap
Maximum: 25.0 mm (0.98 inches)
Recommended: 3.0 mm (0.12 inches)
Minimum: 1.27 mm (0.05 inches)
The Label Stop Sensor must be able to detect the extreme front edges of
the labels.
Opacity
The difference between in opacity between label plus liner and liner only
should be ≥ 19% units.
Maximum liner opacity is 72%.
Media Type Setup
• Label (w gaps)
To Next Page
Loading...
