Intermec EasyCoder PX6i - Recommended Paper Type Settings (Europe)

148 EasyCoder PX6i User’s Guide (Fingerprint version)
Appendix D — Intermec Supplies
Recommended Paper Type Settings (Europe)
Direct Thermal Printing; 8 dots/mm (203.2 dpi)
Type/Speed Name Label Label Max Rec. Print Speed
1
Constant Factor Dir 1&3
2
Dir 2&4
3
Top Coated/ Thermal Top Board
4
100 40 200 100
Standard Thermal Top 77 40 150 200
Thermal IR 98 40 200 100
Non Top Coated/ Thermal Eco 69 40 200 200
Standard Thermal Eco Board
4
68 40 200 150
Top Coated/High Thermal Top High Speed 85 40 225 225
Thermal Transfer Printing; 8 dots/mm (203.2 dpi)
Type/Speed Name Ribbon Ribbon Label Max Rec. Print Speed
1
Constant Factor Offset Dir 1&3
2
Dir 2&4
3
GP02 TTR Uncoated 60 25 0 225 225
TTR Coated 58 25 0 225 225
TTR Premium 54 25 0 225 225
HP66 TTR Coated 76 25 0 225 225
TTR Premium 68 25 0 225 225
TTR Premium Board
4
95 25 0 225 225
TTR High Gloss White 84 25 0 225 225
TTR Polyethylene 67 25 0 225 225
TTR Gloss Polyethylene 81 25 0 225 225
HP05 TTR Coated 75 25 0 225 225
TTR Premium 66 25 0 225 225
TTR Premium Board
4
82 25 0 225 225
TTR High Gloss White 78 25 0 225 225
TTR Polyethylene 64 25 0 225 225
TTR Gloss Polyethylene 76 25 0 225 225
HR03 TTR High Gloss Polyester 81 25 0 175 225
1
/. Exceeding the recommended print speed may cause the printhead to wear out prema-
turely. If the ambient temperature is lower than +15°C (+59°F), decrease print speed by
50 mm/sec.
2
/. Applies to printing of text, lines, boxes, images, and picket fence bar codes.
3
/. Applies to ladder bar codes.
4
/. Requires high printhead pressure (see Chapter 12 “Adjustments, Printhead Pressure”).