EasyCoder PX6i User’s Guide (Fingerprint version) 151
Appendix D — Intermec Supplies
Direct Thermal Printing; 11.81 dots/mm (300 dpi)
Type/Speed Name Label Label Max Rec. Print Speed
1
Constant Factor Dir 1&3
2
Dir 2&4
3
Top Coated/ Duratherm II 94 40 225 225
Standard Duratherm II-2 90 40 225 200
Duratherm II Tag
4
74 40 225 200
Top Coated/ Duratherm Lightning 69 40 225 225
High
Duratherm
Lightning Plus 80 40 225 225
Duratherm
Lightn. IR Tag 113 40 225 100
Thermal Transfer Printing; 11.81 dots/mm (300 dpi)
Type/Speed Name Ribbon Ribbon Label Max Rec. Print Speed
1
Constant Factor Offset Dir 1&3
2
Dir 2&4
3
TMX 1500 Duratran II Label 53 25 0 175 175
Duratran II Syntran 52 25 0 175 175
Duratran Kimdura 56 25 0 175 175
Duratran S 53 25 0 175 175
Duratran II Tag 58 25 0 175 175
TMX 2200 Duratran II Labels 63 25 0 175 175
Duratran II Syntran 64 25 0 175 175
Duratran Kimdura 71 25 0 175 175
Duratran Valeron 82 25 0 175 175
Duratran S 62 25 0 175 175
Duratran II Tag 71 25 0 175 175
TMX 3200 Duratran II Gloss Polyester 83 25 0 200 200
1
/. Exceeding the recommended print speed may cause the printhead to wear out prema-
turely. If the ambient temperature is lower than +15°C (+59°F), decrease print speed by
50 mm/sec.
2
/. Applies to printing of text, lines, boxes, images, and picket fence bar codes.
3
/. Applies to ladder bar codes.
4
/. Requires high printhead pressure (see Chapter 12 “Adjustments, Printhead Pressure”).
To Next Page
Loading...
