Installing the EasyLAN 10i2 Adapter
1-3
1
This chapter provides an overview of the EasyLAN 10i2 adapter and explains how to
install it in your network.
Introducing the EasyLAN 10i2 Adapter
The external EasyLAN
10i2 Ethernet adapter, Part No. 072885, and the internal
EasyLAN 10i2 Ethernet adapters, Part Nos. 072894 and 072884, allow you to share
your available printer resources with everyone on your Ethernet network.
You can connect only the external EasyLAN 10i2 adapter to the following Intermec
printers to print labels:
•
91* printers
•
601XP printers
•
301/E4* printers
•
4630* printers
•
401* and 401LL* printers
•
7421 and 7422* printers
•
501*, 501E*, 501S*, and 501XP printers
•
901/V4* printers
•
C4 printers
*
These printer models require an external power supply to run the external EasyLAN
10i2 adapter.
You can connect either the external or the internal EasyLAN 10i2 adapter Part No.
072894 to the following Intermec printers to print labels:
•
3240 printers
•
3400D and earlier and 3440 printers
•
3600 printers
Note:
For the 3240, 3400D and earlier, 3440, and 3600 printers, you must have the
parallel port option installed on your printer to connect the external EasyLAN 10i2
adapter.
You can connect the EasyLAN 10i2 adapter Part No. 072884 to the 3400e, 4420, and
4440 printers.
Note:
With the internal EasyLAN 10i2 adapter installed, the parallel port on the 3400e,
4420, and 4440 printers is not available for use.
The EasyLAN 10i2 adapter uses a twisted pair (10BaseT) connection with a network
speed of 10 Mbps. Throughout the manual, “EasyLAN 10i2 adapter” is used to refer to
both the internal and external adapter unless specified.
To Next Page
Loading...
Need help?
General
