Configuring the EasyLAN 10i2 Adapter
2-17
2
NetWare Parameters Defined (continued)
Parameter Definition Values
Bindery file
servers
Click either Configure Bindery File Servers or Configure Service
Bindery File Servers. For help, see “To configure bindery file servers and
service bindery file servers” earlier in this chapter.
Frame type Select the frame type. Auto, 802.3, Ethernet
II, 802.2, SNAP
Default = Auto
NetWare password Enter the password the EasyLAN 10i2 adapter uses to communicate with
the file server in the Enter new password field and Confirm new
password field. To disable the password, enter a single space.
Any ASCII characters
Default = blank
Configuring Additional Queues
If you want to configure additional queues, you must use the Novell NWAdmin utility
(this program is usually found in the Public directory on the NetWare file server).
To configure additional queues and ports
1. Start the NWAdmin utility and make sure you are in the right context. (If not, select
NDS Browser from the Tools menu and then browse for the desired context.)
2. Select the container where you want the print queue to reside.
3. From the Tools menu, select Print Services Quick Setup.
4. Browse for the NetWare Print Server by clicking on the button next to the Print
Server Name window.
5. Enter the name of the NDS Printer for the desired port in the Name box (for
example, INTERMEC04ECBA_P1).
6. Leave the Type box at the default Parallel setting.
7. Select the desired banner type.
8. Enter any desired name for the print queue.
9. If necessary, browse for the volume.
10. Click Create to create the print queue. You are now ready to use the queue from a
NetWare workstation.
To Next Page
Loading...
Need help?
General
