Intermec EasyLAN 10I2 User Manual

Console Commands
A-7
A
TCP/IP Commands
Use these console commands to configure and manage TCP/IP parameters.
Command Description
set ip ac status
n.n.n.n
Enables or disables the specified IP address from accessing the
EasyLAN 10i2 adapter. Where
status
equals en for enabled,
dis for disabled, or all for enabling all IP addresses and
n.n.n.n
equals the specific IP address.
set ip ad n.n.n.n
Sets the IP address of the EasyLAN 10i2 adapter. Where
n.n.n.n
equals the IP address.
set ip bo n
Sets the number of BOOTP/RARP tries. Where
n
is the
number of BOOTP/RARP tries.
set ip status
Enables or disables IP processing. Where
status
equals en for
enabled or dis for disabled.
set ip meth stat
Sets IP to static address so that the EasyLAN 10i2 adapter will
not look for a DHCP address.
set ip ra nn
Sets the procedure used by the EasyLAN 10i2 adapter when
obtaining its IP address. By default the IP address is set along
with a default subnet mask and a router address that is the
same as the address of the load host. By setting
nn
to 1, the
subnet mask is not set. If
nn
is set to 2, the router address is not
set. If
nn
is set to 3, neither the subnet mask nor the router
address is set.
set ip ro n.n.n.n
Sets the default router address. Where
n.n.n.n
equals the router
IP address.
set ip su n.n.n.n
Sets the subnet mask. Where
n.n.n.n
equals the subnet mask.
set ip ti n
Sets the inactivity timeout in minutes. Where
n
is the number
of minutes.
set servi servicename
ip status
Enables or disables TCP/IP jobs on the specified
EasyLAN 10i2 adapter. Where
servicename
equals the name
of the service and
status
equals en for enabled or dis for
disabled.
set servi servicename
tcp nn
Sets the TCP port number (>1023) on the specified service.
Where
servicename
is the service you are modifying and
nn
is
the TCP port number.

Intermec EasyLAN 10I2 Specifications

General

Brand	Intermec
Model	EasyLAN 10I2
Category	Adapter
Language	English