Configuring the EasyLAN 10i2 Adapter
2-19
2
NetBIOS Parameters Defined
Parameter Definition Values
NetBEUI protocol Enable or disable communication over the NetBEUI protocol. Enable, Disable
Default = enable
NetBIOS/IP Enable or disable communication over the Internet protocol. Enable, Disable
Default = enable
Enabled services Configure the services on the port you are using. For help, see
“Configuring the Port Services” earlier in this chapter.
Domain name Enter the name of the domain that contains the PCs that will
print to this printer.
Any ASCII characters
Default = INTERMEC
WINS server method Select the server method:
•
Set to Auto to use DHCP to set the primary and secondary
WINS server IP addresses. To use DHCP, you must set
the boot method in the Configure TCP/IP page to either
Auto or DHCP.
•
Set to Static to always use the values you enter in the
Primary WINS Server IP Address row and Secondary
WINS Server IP Address row. To disable WINS
registration, select Static and set the primary and
secondary WINS server IP addresses to 0.0.0.0.
Auto, Static
Default = Auto
Primary WINS server IP
address
Enter the IP address for the primary WINS server.
n.n.n.n
where
n
is from
0 to 255
Default = 0.0.0.0
Secondary WINS server IP
address
Enter the IP address for the optional secondary WINS server.
n.n.n.n
where
n
is from
0 to 255
Default = 0.0.0.0
Configuring the DLC Parameters
Data link control is an error-correction protocol in the Systems Network Architecture
(SNA) responsible for transmission of data between two nodes over a physical link. If
you do not want to use the default settings, use the Web browser interface to configure
the DLC parameters.
To configure the DLC parameters
1. From the Configuration and Management page, click Configure DLC Settings. The
Configure DLC page appears. For help opening the Configuration and Management
page, see “Opening the Web Browser Interface” earlier in this chapter.
To Next Page
Loading...
Need help?
General
