Intermec EasyLAN 10I2

Configuring the EasyLAN 10i2 Adapter
2-7
2
TCP/IP Parameters Defined (continued)
Parameter Definition Values
Keepalive timer Enter how often in minutes the EasyLAN 10i2 adapter sends an IP
ping packet to the router to keep the router aware of the EasyLAN
10i2 adapter. Enter zero to disable this feature.
0 to 255
Default = 0
Probe idle connections Set the EasyLAN 10i2 adapter to send a probe packet on TCP
connections with no data traffic. If the EasyLAN 10i2 adapter does
not receive an acknowledgement, it closes the connection.
Enable, Disable
Default = Disable
TCP receive checksum Set the EasyLAN 10i2 adapter to compute the TCP checksum on
received packets. Disabling this feature can enhance performance, but
data corruption will not be checked.
Enable, Disable
Default = Enable
Configuring the Access and Update Passwords
Use the Web browser interface to configure the access and update passwords. The
default passwords are intermec. The access password is the password you use to get to
the Configuration and Management page of the Web browser interface. The update
password is the password you use to reload the firmware.
To configure the access and update passwords
1. From the Configuration and Management page, click Configure Passwords. The
Configure Password page appears. For help opening the Configuration and
Management page, see “Opening the Web Browser Interface” earlier in this chapter.