Intermec EasyLAN 10I2 User Manual

Console Commands
A-3
A
This appendix explains how to send the console commands and lists the commands.
Sending the Console Commands
You can send console commands to the EasyLAN 10i2 adapter by using either Telnet or
the Web browser interface. The following procedure explains how to use the Web
browser interface. For help using Telnet, see the documentation for Telnet.
If you are using the Console mode from the Web browser interface to send commands,
you should only use commands that show information, such as
sh port
, which shows
the port parameters, or commands that do not have an equivalent Web page. Most of the
parameters that you can configure using console commands can also be configured
through the configuration pages of the Web browser interface. Using console commands
to configure the EasyLAN 10i2 adapter can interfere with your connection through the
Web browser where as the configuration pages of the Web browser interface have ways
to minimize the disruption to your connection.
To send the console commands
1. From the Configuration and Management page, click Access the Console to Send
Commands. The Console page appears. For help opening the Configuration and
Management page, see “Opening the Web Browser Interface” in Chapter 2.
2. Enter the commands you want to send in the field, and then click Enter. For a list of
commands, see the next sections.

Intermec EasyLAN 10I2 Specifications

General

Brand	Intermec
Model	EasyLAN 10I2
Category	Adapter
Language	English