EasyLAN 10i2 Ethernet Adapter User’s Manual
1-12
Setting Up for a Windows 2000/XP PC
Before you install the printer on a Windows 2000/XP PC, you need to install the
InterDriver for your printer. For help installing the InterDriver, see the Software page
for your printer on the PrinterCompanion CD.
To install the printer, use the Add Printer wizard to add your printer using the following
settings when prompted:
•
Choose Local Printer.
•
Choose Create a new port and then Standard TCP/IP Port.
•
Choose the InterDriver for your printer.
After you install the printer as a TCP/IP port, you are ready to print to it.
Installing and Using the Intermec Print Monitor
If you want to install the printer so that you can print over your Ethernet network from a
Windows 95/98 system, you must install the Intermec print monitor. The Intermec print
monitor is available on the PrinterCompanion CD that shipped with your printer. This
print monitor creates a network port for the Ethernet link on a Windows 95/98 system.
As a result, the port acts transparently with any printer driver for Intermec printers and
any application program. Because this print monitor uses TCP/IP, it can be used with IP
routers and other IP-based equipment.
To install the print monitor
1. Place the PrinterCompanion CD in your PC’s CD drive. The PrinterCompanion
page appears.
To Next Page
Loading...
Need help?
General
