Invacare Solara - STABILITY - RECLINER MODELS ONLY

SECTION 1—GENERAL GUIDELINES
Part No 1085787 15 Solara
™
and Solara
™
Limited
STABILITY - RECLINER MODELS ONLY
Before using any recline position of this wheelchair, make sure the rear wheels are in the
most rearward position in the axle mounting plate to maintain the stability of the
wheelchair. DO NOT change the handling/maneuverability of the wheelchair by moving
the rear wheels to any of the forward positions. Moving the rear wheels to any of the
forward positions will change the center of gravity of the wheelchair, making the
wheelchair less stable.
ALWAYS make sure that the wheelchair is stable in the full reclined (back at 180°) position
and the full upright (back at 90°) position before using the recliner option.
Before using the recliner option, make sure the anti-tipper wheel assemblies are in the
lowest adjustment hole (adjustment hole closest to the ground/floor).
ALWAYS engage both wheel locks while reclining or inclining (reverse recline) the
wheelchair.
Both gas cylinders MUST be operational and adjusted properly before using the recliner.
DO NOT operate the recliner option if only one (1) of the gas cylinders is operational or
adjusted properly.
Make sure the occupant of the wheelchair is properly positioned in the wheelchair before
reclining or inclining (reverse recline) to maintain maximum stability and safety.
When returning the occupant of the wheelchair to the full upright position, more body
strength will be required for approximately the last twenty (20) degrees of incline (reverse
recline). Make sure to use proper body mechanics (use your legs) or seek assistance to
avoid injury.
ALWAYS return the back to the upright position before lifting the wheelchair.
OPERATING INFORMATION
DO NOT overtighten hardware attaching to the frame. This could cause damage to the
frame tubing.
Unless otherwise noted, all service and adjustments should be performed while the
wheelchair is unoccupied.
DO NOT use the wheelchair unless it has the proper tire pressure (p.s.i.). DO NOT
overinflate the tires. Failure to follow these suggestions may cause the tire to explode and
cause bodily harm. The recommended tire pressure is listed on the side wall of the tire.
ALWAYS check foam grips for looseness before using the wheelchair. If loose, contact a
qualified technician for instructions.
The necessary back angle (90°, 100°, 110° or 120°) MUST be selected before repositioning
the rear wheels forward.
DO NOT operate the tilt-in-space if the trigger release levers and cables are not properly
adjusted to ensure that the tilt-in-space is locked in place when engaged.
DO NOT use any parts, accessories, or adapters other than those authorized by Invacare.