SECTION 4—ASSEMBLY
Solara
™
and Solara
™
Limited 20 Part No 1085787
SECTION 4—ASSEMBLY
WARNING
BEFORE performing this procedure, refer to General Guidelines on page 13 for
additional requirements.
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
ASSEMBLING THE SOLARA WHEELCHAIR
NOTE: Refer to FIGURE 4.1 for this procedure.
1. Unpack the contents of the Solara wheelchair shipping carton.
2. Unfold the back. Refer to Folding/Unfolding Back Assembly in the Owner’s Manual,
part number 1080556.
3. Install the rear wheels. Refer to Installing/Removing Rear Wheels in the Owner’s
Manual, part number 1080556.
4. Install the front caster/fork assemblies. Refer to Installing/Removing/Adjusting
Caster/Fork on page 44.
5. Install the front riggings or contracture assembly. Refer to Front Riggings or
Contracture Footplate Option in the Owner’s Manual, part number 1080556.
6. If necessary, install the wheel locks. Refer to Removing/Installing Wheel Locks on
page 50.
7. Install the anti-tippers. Refer to Installing/Adjusting Anti-tippers in the Owner’s
Manual, part number 1080556.
8. If necessary, adjust the back angle. Refer to Adjusting Back Angle
on page 40.
9. If necessary, reposition the rear wheels.Refer to Repositioning Axle Plate on page 48.
To Next Page
Loading...
