SECTION 5—SEAT
Solara
™
and Solara
™
Limited 22 Part No 1085787
SECTION 5—SEAT
WARNING
After any adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
REMOVING/INSTALLING SEAT PAN
FLUSH MOUNT
NOTE: Refer to FIGURE 5.1 for this procedure.
REMOVING
1. Remove the seat cushion from the seat pan.
2. Do one (1) of the following:
A. Short Frame - Remove the four (4) mounting screws and locknuts that secure
existing seat pan and seat pan supports to wheelchair frame.
B. Medium or Long Frame - Remove the six (6) mounting screws, locknuts and two
(2) coved spacers that secure the existing seat pan and seat pan supports to the
wheelchair frame.
INSTALLING
1. Install new seat pan and existing seat pan supports onto the wheelchair frame as
shown in FIGURE 5.1.
2. Do one (1) of the following:
A. Short Frame - Secure the seat pan and seat pan supports to the wheelchair frame
with the four (4) mounting screws and locknuts.
B. Medium or Long Frame - Secure the seat pan and seat pan supports to the
wheelchair frame with the six (6) mounting screws, locknuts and two (2) coved
spacers. Refer to FIGURE 5.1 for proper hardware orientation.
3. Reinstall seat cushion onto seat pan.
To Next Page
Loading...
