INVT DA180-S4R5SG0 User Manual

DA180 series basic AC servo drive Function codes
-156-
6.5.5 Special commands
P4.90*
Fault recovery
Setting
range
Default
Unit
Applicable
mode
0–1
0
-
P
S
T
This parameter specifies whether to enable fault recovery. You can set this parameter on the upper
computer to handle faults for the drive.
Setting
Meaning
[0]
Disable
1
Enable
Note:
 If fault recovery is enabled, the servo is not enabled for the drive, and the fault occurring
condition is not triggered, the fault that can be automatically cleared recovers automatically.
Other faults cannot be automatically cleared online but can be cleared after repower-on.
 You can set this parameter on the LED panel to clear faults.
P4.90*
Data size
16bit
Data format
DEC
Modbus address
1980, 1981
CANopen address
0x245A, 0x00
P4.91*
Parameter saving
Setting
range
Default
Unit
Applicable
mode
0–1
0
-
P
S
T
If P0.17 is set to 1 (saving in batches), this parameter can be used to send a parameter saving
command so that any parameter modification can be written to the EEPROM.
Setting
Meaning
[0]
Disable
1
Enable
P4.91*
Data size
16bit
Data format
DEC
Modbus address
1982, 1983
CANopen address
0x245B, 0x00
P4.92*
Factory restore
Setting range
Default
Unit
Applicable
mode
0–1
0
-
P
S
T
This parameter specifies whether to enable the function of restoring factory settings. If the function
is enabled, all user parameters (from group P0 to group P6) are restored to factory settings.
Setting
Meaning
[0]
Disable
1
Enable
P4.92*
Data size
16bit
Data format
DEC
Modbus address
1984, 1985
CANopen address
0x245C, 0x00

INVT DA180-S4R5SG0 Specifications

General

Brand	INVT
Model	DA180-S4R5SG0
Category	Servo Drives
Language	English