INVT Goodrive35 Series User Manual

Goodrive35 Series Closed-loop Vector Control VFD Function parameters
84
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modif
y
4: Download the keypad function parameters to local
address (only for the motor parameter of P02 and
P12 group)
Note: After completing the 1–4 operations, the
parameter will come back to 0 automatically; the
function of upload and download excludes the
factory parameters of P29.
P07.02
QUICK/JOG
function selection
0: No function
1: Jogging. Press QUICK/JOG to begin the jogging
running.
2: Shift the display state by the shifting key. Press
QUICK/JOG to shift the displayed function code
from right to left.
3: Shift between forward rotations and reverse
rotations. Press QUICK/JOG to shift the direction of
the frequency commands. This function is only valid
in the keypad commands channels.
4: Clear UP/DOWN settings. Press QUICK/JOG to
clear the set value of UP/DOWN.
5: Coast to stop. Press QUICK/JOG to coast to stop.
6: Shift the given manner of running commands.
Press QUICK/JOG to shift the given manner of
running commands.
7: Quick commission mode (commission according
to the non-factory parameter)
Note: Press QUICK/JOG to shift between forward
rotation and reverse rotation, the VFD does not
remember the state after shifting during powering
off. The VFD will run in the running direction set
according to parameter P00.13 during next powering
on.
1
◎
P07.03
Shifting sequence
selection of
QUICK/JOG
commands
When P07.06=6, set the shifting sequence of
running command channels.
0: Keypad control→terminals control
→communication control
1: Keypad control←→terminals control
2: Keypad control←→communication control
3: Terminals control←→communication control
0
○

INVT Goodrive35 Series Specifications

General

Brand	INVT
Model	Goodrive35 Series
Category	Controller
Language	English