84
Inxpect SRE 200 Series| Instruction manual v1.5 DEC 2023 |Inxpect SAF-IM-200S_5m_7_00047_en_v1.5|© 2021-2023 Inxpect SpA
8. Installation and use procedures
8.7.8 Change Fieldbus parameters
In Admin > Fieldbus Parameters, change the F-addresses and the Fieldbus Endianness of the control unit if the
control unit is provided with a PROFIsafe interface; or the Safe Address if it is provided with a Safety over
EtherCAT® interface.
8.7.9 Set system labels
In Admin > System labels, choose the desired labels for the control unit and the sensors.
To Next Page