5. Link the KNX group addresses to KNX buttons, visualisations etc.
- Play and Next/previous track can be linked to switching objects of buttons or status objects
of visualisations;
- Relative volume is linked to a standard dimmer switch object.
- Slave 1 – Switch group association (add other room to the current room as a slave) or Exit
slave mode (remaster, i.e. make the Sonos device in the current room the master and thus
remove it from the other room as a slave if applicable) can also be connected with binary
objects of buttons.
A schematic representation of the "assignment" of the Sonos devices to the ise smart connect KNX
Sonos and the respective parametrisation can be found on the following page.
To Next Page
Loading...
