ISE Sonos - LED Status Display in Operation

ise smart connect KNX Sonos
Commissioning
Order No. 1-0001-002
Product Manual Page 54 (76)
LED status display in operation
Once device start-up is complete, the meaning of the LEDs is as follows:
LED "APP" (green)
Meaning
Green
Normal operation
Off
Device in start-up procedure or out of operation:
Wait until the start-up procedure is complete or check the power supply
Flashes at approx. 1 Hz
Error:
Application is not parametrised or not fully parametrised.
Check the device parametrisation in the ETS and carry out an application
download to the device.
Three slow flashes fol-
lowed by a 2 s pause
Note:
At present, not all configured Sonos devices can be reached. If devices
are switched off to save power, an error is not in effect
LED "COM" (yellow)
Meaning
Yellow
Normal operation:
KNX connection is established, no KNX telegram traffic.
Yellow with brief
dark phases
Normal operation:
KNX connection is established,
KNX telegram traffic.
Off
Error:
Connection to KNX is interrupted.
Check the bus connection