ISE Sonos - KNX Group Objects for Dynamic Group Creation

ise smart connect KNX Sonos
Configuration
Order No. 1-0001-002
Product Manual Page 42 (76)
6.6 KNX group objects for dynamic group creation
The ise smart connect KNX Sonos supports the dynamic group creation of the Sonos devices. You can
influence the integration of individual Sonos slaves into a group with the group objects from the bus
outward listed in the following.
Notes:
 For each master, up to five slaves can be parametrised to form a master-slave group (MSG) (see
6.4.2) which can be assigned as a slave to the master dynamically via group objects/KNX group
telegrams.
 The slaves can be connected to or disconnected from the zone individually via 1-bit group objects.
 The default volume control and status response are available for each slave.
 The relative volume control of a group is implemented via the group volume.
 The state of the connection is saved only in the Sonos system. If the auxiliary voltage fails and then
returns, the ise smart connect KNX Sonos reads the connection state from the Sonos system again
via UPnP.
 To use group support, automatic detection (master IP address 0.0.0.0) cannot be parametrised.