Initial display
If the device is properly configured and the master of the first ise smart connect KNX Sonos group is
accessible, the start page displays the available sources. The device loads the sources from Sonos
Playlists and My Radio Stations configured with the Sonos software. Here, all playlists are displayed
first, followed by all stations, in alphabetical order.
Saving the configuration
The button to Save the configuration is only active if the displayed configuration of the respective group
has not yet been saved.
This is also the initial state of the first commissioning of each group. This means that, for example, the
positions of the radio stations can change if a Sonos Playlist is added with the Sonos software. Only
saving the configuration ensures that a certain music source can always be reached using the issued
number.
Deleting and creating a separate list
The Clear button clears the current list. If this cleared list is saved, the page again displays the availa-
ble sources after reloading.
To create a user-defined list, a source type can be selected for each of the available 255 storage loca-
tions. Possible source types are Sonos Playlists and My Radio Stations. The name of the source can
then be entered under Source. If the source exists in the Sonos application, it is displayed in the selec-
tion list. The selection list is limited to 100 entries on the display. A source not displayed in the selection
list can easily be assigned by entering its name, however. Naturally, it is possible to build up an internal
system (e.g. through the use of number ranges) by "omitting" individual numbers.
To delete a default setting, it is sufficient to set the source type of the corresponding number to the
Please select a source type placeholder and save the configuration.
Note: The groups can also be configured without a connection to the Sonos system to be used later on.
It is thus possible for the end user to do this before using the ise smart connect KNX Sonos. The re-
quirement here, however, is that the sources to be saved with the respective number be entered with
their future name (using the proper notation used in the Sonos system). The naming conventions of the
Sonos system (e.g. number of characters) are to be observed here. Please also note that when you are
using the same source in multiple slots, skipping to the next slot may not start playback of the expected
source, for example. The reason for this is that the slot number is determined from the source name,
which is no longer unique in this case. This is why we recommend using a certain source only once in
the configuration in a master-slave group.
To Next Page
Loading...